Sound familiar?
These are the problems sheet metal workers tell us about every week.
Fabricating duct runs from outdated plans and discovering conflicts during install
Coordinating duct routing with plumbing, electrical, and sprinkler in tight ceiling plenums
Tracking which duct sections are fabricated, hung, and sealed across large floor plates
Getting field measurements that do not match the plan dimensions
How HomeFloorPlan helps
HVAC layer
See duct layouts, sizes, and routing paths filtered to your scope. Skip all non-mechanical sheets.
Conflict coordination
Pin duct routing conflicts with other trades. Tag the GC to coordinate a resolution.
Mobile access
Pull up duct details and fitting schedules on your phone while on the lift.
Punch list tracking
Pin duct defects to exact locations. Track sealing, insulation, and balancing items.
Built by a contractor, for the construction industry
Sheet metal workers fabricate and install ductwork, kitchen hoods, and architectural sheet metal. HomeFloorPlan gives you an HVAC layer where you can review duct routing, verify sizes, and coordinate with other trades sharing the same ceiling space.